Simple soic-8 opamp prototyping board for use with a breadboard.
Both VCC and VEE have pads for 2 decoupling caps (0805 and 1206, TH is possible too). The VCC, VEE and GND traces have 0805 pads inline for either small value resistors, ferrite beads or you can just jump them with a 0R jumper or solder jumper.
<------------------------------------------------------------------------------------------------------------------------------->
Copyright (c) 2016 Thomas Hopman
This documentation describes Open Hardware and is licensed under the CERN OHL v. 1.2. You may redistribute and modify this documentation under the terms of the CERN OHL v.1.2. (http://ohwr.org/cernohl). This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN OHL v.1.2 for applicable conditions