net/mlx5e: Sync netdev vxlan ports at open

When mlx5_core is loaded it is expected to sync ports
with all vxlan devices so it can support vxlan encap/decap.
This is done via udp_tunnel_get_rx_info(). Currently this
call is set in mlx5e_nic_enable() and if the netdev is not in
NETREG_REGISTERED state it will not be called.

Normally on load the netdev state is not NETREG_REGISTERED
so udp_tunnel_get_rx_info() will not be called.

Moving udp_tunnel_get_rx_info() to mlx5e_open() so
it will be called on netdev UP event and allow encap/decap.

Fixes: 610e89e ("net/mlx5e: Don't sync netdev state when not registered")
Signed-off-by: Shahar Klein <[email protected]>
Reviewed-by: Roi Dayan <[email protected]>
Signed-off-by: Saeed Mahameed <[email protected]>

drivers/net/ethernet/mellanox/mlx5/core/en_main.c

@@ -2572,6 +2572,9 @@ int mlx5e_open(struct net_device *netdev)
 		mlx5_set_port_admin_status(priv->mdev, MLX5_PORT_UP);
 	mutex_unlock(&priv->state_lock);
 
+	if (mlx5e_vxlan_allowed(priv->mdev))
+		udp_tunnel_get_rx_info(netdev);
+
 	return err;
 }
 
@@ -4327,12 +4330,6 @@ static void mlx5e_nic_enable(struct mlx5e_priv *priv)
 #ifdef CONFIG_MLX5_CORE_EN_DCB
 	mlx5e_dcbnl_init_app(priv);
 #endif
-	/* Device already registered: sync netdev system state */
-	if (mlx5e_vxlan_allowed(mdev)) {
-		rtnl_lock();
-		udp_tunnel_get_rx_info(netdev);
-		rtnl_unlock();
-	}
 
 	queue_work(priv->wq, &priv->set_rx_mode_work);