forked from Distrotech/libss7
-
Notifications
You must be signed in to change notification settings - Fork 0
/
Copy pathNEWS-09-11-2006
16 lines (9 loc) · 2.23 KB
/
NEWS-09-11-2006
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Hey all, long time no see, but I just wanted to give a status update on what is going on with libss7. Last week I was able to commit my alarm detection code (in case you get an alarm on your spans that have signalling channels). It should restart the link when it comes out of alarm fine. I think I need to get some more testing in though, since I mostly just wrote the code and did very rudimentary testing on it. I also just added today support in zapata.conf for national_spare and international_spare networkindicator options in case your link uses the spare network indicator values (someone on the list today had a problem with that).
On an entirely different note, I got an ANSI style link working this week!!!! I didn't ask permission to see if they minded being mentioned, so I won't mention any names for now, however it was a night to remember. It was over a 56kbps link channel, using an older switch. It went surprisingly easier than I thought it would. MTP2 was already working well, MTP3 only had slight modifications, and ISUP had the most changes. Other than the fact that I'd never seen a 56kbps link before. Basically, the difference was that they don't use the top bit in a DS0 timeslot for HDLC code. So if you want to try out libss7 on your ANSI link, this is how you do it:
Disclaimer: You have to be using either a TE2xxp or TE4xxp for this to work, since I used the hardware hdlc features of the framer of that card to do the 56kbps link.
Get current zaptel-trunk, libss7, and asterisk-ss7 from svn (You may also have to get libpri, I haven't checked if chan_zap compiles cleanly without libpri installed)
Build them, and install them.
If you are using 56kbps links, when you load the wct4xxp.ko module, you have to pass it the parameter hardhdlcmode=0x7f and instead of using "dchan" in zaptel.conf for your signalling channel, you need to use "hardhdlc" on that channel.
In zapata.conf, setup your link following the pattern in the sample zapata.conf that comes with asterisk-ss7 and set your ss7type=ansi. That should pretty much be it. All the rest of the configuration is the same.
As always, if you have any more questions, comments, requests, or anything else that matter, let me know. I'd love to get feedback.
Matthew Fredrickson