👈 Back to main page

Wiring Diagram - OSWW

Connect the Pi Pico's VBUS pin to the 5V input of the L298N driver board (red wire)
Connect a ground from the Pi Pico the L298N driver board (black wire)
Connect the L298N driver board's 5V and 12V terminals together (red jumper wire)
Make sure the L298N's jumpers are in place (small blue wires on board)
Connect the Pi Pico's GPIO10 to IN1 on the L298N driver board (yellow wire)
Connect the Pi Pico's GPIO11 to IN2 on the L298N driver board (blue wire)
Connect the DC motor to channel 1 on the L298N driver board.
- Note: polarity does not matter here
- You may add a in-line switch between the motor and the L298N driver board; this will enable and disable winding

Provide feedback