Time lapse mixing cameras from different printers

[khisanthax]

So, first let me say that I'm not sure this is exactly the right spot for this. I'm using Sonic pad an inside that I'm using mainsail. So on my Sonic pad I currently have three printers set up via USB and on each of those printers I have an IP camera that is attached to each printer. When I look at the webcam it shows fine no problem and when I set up the time lapse I'm choosing the correct camera. If I go to the time lapse section where it shows me the files and the current image that's being taken a picture of or whatever frame is being saved it shows the correct camera. However when it finishes rendering it may start off with camera one but in the middle of the render it'll have camera two and the end of the render will have camera 3.

So it looks like if I have three print jobs running then the file that gets rendered has a bunch of frames from each camera and this is using hyperlapse. So assuming this is the right spot for this is there a way to fix this or my only allowed to run one print job and one camera at a time?