Fossil fuel percentage

[xsirpreisx]

This probably doesn't have anything to do with the card, but I just noticed something that I can't yet explain myself.

These days our house is mostly self-sufficient (battery/solar), but sometimes a little bit of power is consumed from the grid.

Just like a minute or two ago.

What I noticed was that the power displayed by the fossil fuel circle (which uses the sensor.co2_signal_co2_intensity; it was about 190 watts at that point) is higher than the power that is imported from the grid (about 130 watts). This is the cases every time we do consume something from the grid.

Is that normal behaviour? Or maybe a wrong calculation (could look into the code myself, I guess, but a little short on time)?

[xsirpreisx]

I guess that might have been my own mistake. I just took the configuration section for fossil fuel from your documentation. So I was using the "intensity" entity instead of the "percentage" one. I just changed that and I think that might have done the job :-)

[flixlix]

Do you think we can close this discussion?

[xsirpreisx]

Sure. I guess I could have also opened an issue instead (even though there never really was an issue). Still getting used to Github...