The keyboard does not remember the LED toggle state after power cycle.

[chengxianghu]

Describe the bug
The keyboard does not remember the LED toggle state after power cycle:

(1) When Raise's LED is toggled OFF by pressing the key that I assigned "LED toggle" to, and when the laptop that Raise is connected to is in sleep mode, sometimes my Raise's LED blinks out of nowhere. But most of time, when this issue happens, the LED powers on and stays on until I go and toggle it off by pressing the key that I assigned "LED toggle" to.

(2)After reconnecting Raise to PC, Raise's LED turned on itself even though it was toggled off by pressing the key i assigned "LED toggle" to, before I put my PC to sleep and disconnect Raise from laptop.

To Reproduce
Cannot reproduce (1) as it happens randomly.

Steps to reproduce the behavior for (2):
(1) turn off LED by pressing the key that I assigned "LED toggle" to
(2) put my laptop to sleep mode
(3) disconnect Raise usb from laptop
(4) reconnect Raise to the laptop
(5) press any key on the Raise to wake up laptop, the Raise's LED will be on at the time when laptop wakes up even though it was toggled OFF previously

Expected behavior
(1) I toggle Raise's LED to OFF by pressing the key that I assigned "LED toggle", then I put my laptop to sleep. Before I wake up my laptop, the Raise's LED should remain OFF.

(2) I toggle Raise's LED to OFF by pressing the key that I assigned "LED toggle". I put my laptop to sleep and disconnect Raise. Then I reconnect Raise to the laptop, and I wake up my laptop by pressing any key on the Raise, the Raise's LED should remain OFF.

Desktop (please complete the following information):

• OS: macOS Monterey 12.6.1
• Bazecor Version: Version 1.0.0-RC (1.0.0-RC)
• Raise's firmware Version: v1.0.9beta

[tarbari]

This is reproducable on Windows 11 as well. This might be a "feature" of the Raise Firmware rather than a bug in Bazecor.

Steps:

1. Make sure LED brightness is not set to 0 in Bazecor
2. Press LED Toggle key to turn LEDs off
3. Unplug and replug the keyboard

Now the LEDs are back on.

Haven't tested on other firmware versions. I would have expected LED Toggle to behave as @chengxianghu described.

[alexpargon]

i will push this bug to the FW repos, cause this is a FW issue! it shouldn't be happening 👍🏻